View source for Voron 2.4 Build

== Parts ==

* [https://www.aliexpress.com/item/1005001393141303.html?spm=a2g0s.9042311.0.0.45794c4d48uSKB Funssor MIC-6 8mm Aluminum build plate]

== FYSETC Spider Controller ==

=== Bootloader Setup ===

Installation of the bootloader/firmware is a little confusing and I initially thought I had a bad board. I haven't been able to install bootloader or firmware without shorting the BOOT0 pins to force DFU mode. Here's the general process:

# Install jumper on BT0 pins and power on
# Launch STM32CubeProgrammer, select USB, and Connect
# Click the Erasing and Programming tab, and then:
## Pick the '''Bootloader_FYSETC_SPIDER.hex''' bootloader from the FYSETC Spider GitHub Repo
## Select '''Verify programming''' and '''Full Chip Erase'''
## Click '''Start Programm..'''
# Next install the firmware (previously compiled)
## Uncheck the '''Full chip erase''' checkbox
## Choose the firmware. After compiling, it can generally be found in the '''<<install path>>'''firmware/Marlin/.pio/build/FYSETC_S6_8000
## '''IMPORTANT:''' Change the Start addr.. to 0x0800'''8000'''. For some reason the bootloader now looks for the firmware at the 8000 location vs the default 0x08000000
## Click '''Start Programm...''' to write the firmware
# Remove the BT0 pin and restart

== Firmware (Marlin) Configuration ==

=== configuration.h ===

<pre>
#ifndef MOTHERBOARD
  #define MOTHERBOARD BOARD_FYSETC_SPIDER
#endif

#define SERIAL_PORT -1

#define TEMP_SENSOR_BED 11
</pre>