|
|
| (70 intermediate revisions by the same user not shown) |
| Line 1: |
Line 1: |
| == Tips for Pulling Engine ==
| | * [[99 Ford Explorer Timing/Heads Gasket Replacement]] |
| | | * [[Engine Break In]] |
| === Prep ===
| | * [[Rough Idle]] |
| # Spray Rust Pentrant
| | * [[DIY Paint]] |
| ## Exhaust Manifold
| |
| ## Engine Mounts
| |
| # Drain Coolant
| |
| # Drain Oil
| |
| # Mark Plug Wires
| |
| | |
| === Underneath ===
| |
| # Disconnect Exhaust Manifold
| |
| # Mark Bolt on Torque Converter w/ White Paint
| |
| | |
| === Front ===
| |
| # Alternator
| |
| # Power Steering
| |
| # Compressor
| |
| # Intake (Upper and Lower)
| |
| # Fan, Radiator, Condensor
| |
| | |
| === Engine Mount ===
| |
| # Remove Engine Mount to Frame Nuts
| |
| # Loosen Engine Mount to Engine Bolts
| |
| # Once Engine is on Hoist slightly, remove engine mount entirely to make it easier to dismount/mount transmission
| |
| | |
| === Fuel ===
| |
| # Depressurize
| |
| # Remove fuel line (cover in
| |
| | |
| === Initial Lift ===
| |
| | |
| # Support transmissision w/ jack and block of wood
| |
| # Lift Engine Slightly
| |
| # Remove last 2 bellhousing bolts
| |
| # Remove Engine Mount Brackets
| |
| # Disconnect fuel line (do it last so you don't smell fuel)
| |
