No edit summary
 
(66 intermediate revisions by the same user not shown)
Line 1: Line 1:
== Tips for Pulling Engine ==
* [[99 Ford Explorer Timing/Heads Gasket Replacement]]
 
* [[Engine Break In]]
=== Prep ===
* [[Rough Idle]]
# Spray Rust Pentrant
* [[DIY Paint]]
## Exhaust Manifold
## Engine Mounts
# Drain Coolant
# Drain Oil
# Mark Plug Wires
 
=== Underneath ===
# Disconnect Exhaust Manifold
# Mark Bolt on Torque Converter w/ White Paint
 
=== Front ===
# Alternator
# Power Steering
# Compressor
# Intake (Upper and Lower)
# Fan, Radiator, Condensor
 
=== Engine Mount ===
# Remove Engine Mount to Frame Nuts
# Loosen Engine Mount to Engine Bolts
 
=== Initial Lift ===
 
# Connect chains to front of left head and back of right head
# Support transmissision w/ jack and block of wood
# Lift Engine Slightly
# Remove last 2 bellhousing bolts
# Remove Engine Mount Brackets
# Disconnect fuel line (do it last so you don't smell fuel)
 
=== Remove ===
# Raise a few Inches
# Shake free from transmission
# Verify that everything is free
# Gently raise a few inches at a time verifying clearances
# Raise to clear front radiator area, drag engine free, but move very slowly to prevent a tip
# Once clear of truck, lower to reduce center of gravity

Latest revision as of 04:57, 13 August 2021