CAD Dimensions: Difference between revisions
(→M3) |
|||
| (3 intermediate revisions by the same user not shown) | |||
| Line 6: | Line 6: | ||
* M3 Socket Head = 6mm | * M3 Socket Head = 6mm | ||
* M3 Support Nut Slot = 2.62 x 5.65 x 5.14mm past center of screw path | * M3 Support Nut Slot = 2.62 x 5.65 x 5.14mm past center of screw path | ||
* M3 Socket = 5.6 cap, 3.1 deep, 3.1 shaft | |||
== M5 == | == M5 == | ||
| Line 12: | Line 13: | ||
== Extrusion Rails == | == Extrusion Rails == | ||
Draw an 8.5mm tall square the length of the part and extrude by 1.5mm | # Draw an 8.5mm tall square the length of the part and extrude by 1.5mm | ||
Add a 1.5mm chaffer to top and bottom | # Add a 1.5mm chaffer to top and bottom | ||
== Micro Endstop == | |||
# 13.10 x 6.10 (tight fit) | |||
# Screw holes are 3.5mm from centerline, 5.28mm from front | |||
Latest revision as of 05:46, 7 August 2024
I found myself having to go back and look these up in past designs, so here's a list of commonly used dimensions that seem to work w/ my printers.
M3
- M3 Nut = 2.825 (radius)
- M3 Hole = 3mm
- M3 Socket Head = 6mm
- M3 Support Nut Slot = 2.62 x 5.65 x 5.14mm past center of screw path
- M3 Socket = 5.6 cap, 3.1 deep, 3.1 shaft
M5
Extrusion Rails
- Draw an 8.5mm tall square the length of the part and extrude by 1.5mm
- Add a 1.5mm chaffer to top and bottom
Micro Endstop
- 13.10 x 6.10 (tight fit)
- Screw holes are 3.5mm from centerline, 5.28mm from front