F-18: Difference between revisions

Revision as of 05:23, 18 July 2022

Targeting Pod Setup
1. From R console, put FLIR into standby (this take a few minutes to warm up)
2. From PFD, click Menu, FLIR
3. Once Targeting Pod is Operational, ARM laser from R Console
4. Can confirm laser is active, L ARM should display on TPOD display
5. Laser must be rearmed after each drop
Configure Airplane for A/G
1. A/G Mode
2. Select LG Bomb
Each LG bomb will have XXXX for it's laser code. We need to set a code
1. Select CODE (bottom left), click "CODE" on UFC, and then type code (ie. 1685) and "ENT" (repeat for each LG bomb)
2. This assigns the laser guided code to that bomb

Select a Target
1. S key resets targeting pod to nose
2. Use Thottle Select Hat to Slew targetting pod
3. Use

@@ Line 7: / Line 7: @@
 ## Can confirm laser is active, L ARM should display on TPOD display
 ## Laser must be rearmed after each drop
-# A/G Mode
+# Configure Airplane for A/G
-# Select LG Bomb
+## A/G Mode
+## Select LG Bomb
 # Each LG bomb will have XXXX for it's laser code. We need to set a code
 ## Select CODE (bottom left), click "CODE" on UFC, and then type code (ie. 1685) and "ENT" (repeat for each LG bomb)