Voron 2.4 Build

Parts

Funssor MIC-6 8mm Aluminum build plate

FYSETC Spider Controller

Bootloader Setup

Installation of the bootloader/firmware is a little confusing and I initially thought I had a bad board. I haven't been able to install bootloader or firmware without shorting the BOOT0 pins to force DFU mode. Here's the general process:

Install jumper on BT0 pins and power on
Launch STM32CubeProgrammer, select USB, and Connect
Click the Erasing and Programming tab, and then:
1. Pick the Bootloader_FYSETC_SPIDER.hex bootloader from the FYSETC Spider GitHub Repo
2. Select Verify programming and Full Chip Erase
3. Click Start Programm..

Firmware (Marlin) Configuration

configuration.h

#ifndef MOTHERBOARD
  #define MOTHERBOARD BOARD_FYSETC_SPIDER
#endif

#define SERIAL_PORT -1

#define TEMP_SENSOR_BED 11